ASTM A – Standard Specification for Annealed or Cold-Worked Austenitic Stainless Steel Sheet, Strip, Plate, and Flat Bar. This standard is a part of ASTM. ASTM A March 10, Standard Specification for Annealed or Cold- Worked Austenitic Stainless Steel Sheet, Strip, Plate, and Flat Bar. This specification. ASTM A – Designation: A – 10 Standard Speci?cation for Annealed or Cold-Worked Austenitic.
|Published (Last):||3 December 2017|
|PDF File Size:||19.37 Mb|
|ePub File Size:||3.30 Mb|
|Price:||Free* [*Free Regsitration Required]|
If you feel that your comments have not received a fair hearing you should make your views known to the ASTM Committee on Standards, at the address shown below.
Originally approved in Number of Tests 8. Type L LN Maximum unless otherwise indicated. A number in parentheses indicates the year of last reapproval.
ASTM A for Annealed or Cold-Worked Austenitic Stainless Steel Sheet, Strip, Plate, and Flat Bar
A — 10 Standard Speci? The noncontrolling factor normally will exceed considerably the speci?
If filler metal is required, Type is normally used. Type L should be used in heavier sections to reduce the occurrence of carbide precipitation in the heat affected region adjacent to awtm weld pool Corrosion: D PSS means plate, strip, sheet. Types and L cannot be hardened by thermal treatment.
These alloys represent an atsm combination of corrosion resistance and fabricability. Chemical equipment and piping, heat exchanger components, dairy and food handling equipment and utensils, cryogenic vessels and components, architectural and structural applications exposed to non-marine atmospheres Chemical Composition: Users of this standard are expressly advised that determination of the validity of any such patent rights, and s666-10 risk of infringement of such rights, are entirely their own responsibility.
This standard is subject to revision at any time by the responsible technical committee and must be reviewed every?
304 and 304L Stainless Steel
Depending on the work hardening characteristics of the particular grade, either the yield or the tensile strength can be the controlling factor in meeting the properties. HardC Elongation in 2 in.
Types and L are weldable by most fusion or resistance welding techniques. Hard Elongation in 2 qstm. The values obtained in this manner should not, however, be taken as the actual yield strength for 0.
Types and L provides corrosion resistance in a wide range of moderately oxidizing and reducing conditions, fresh water and non-marine applications. This revision of Speci? Your comments will receive careful consideration at a meeting of the responsible technical committee, which you may attend. This standard has been approved for use by agencies of the Department of Defense.
and L Stainless Steel – NKS
Rockwell B 95 95 Type L should be used in heavier sections to reduce the occurrence of carbide precipitation in the heat affected region adjacent to the weld pool. Due to the high work hardening rate of these materials, intermediate anneals maybe required to successfully fabricate the part.
In the annealed condition it is essentially non-magnetic and becomes slightly magnetic with the application of cold work. B Type is generally produced with a chemical composition axtm for rich side Type or lean side Type austenite stability depending on the properties required for speci?
Chemical equipment and piping, heat exchanger sstm, dairy and food handling equipment and utensils, cryogenic vessels and components, architectural and structural applications exposed to non-marine atmospheres. Last previous edition approved in as A — Find out what NKS can do for you. However, in the case of dispute, tests shall be made by pressure. Your comments are invited either for revision of this standard or for additional standards and should be addressed to ASTM International Headquarters.